PRAIRIE FIELD NOTES / MONTANA

How to Make a Sewn Handmade Notebook

A plain guide to making a sewn handmade notebook, from folding paper signatures and sewing a saddle stitch to wrapping the sewn spine in a fabric cover.

8 min read0 viewsHow to Make a Sewn Handmade Notebook
— · 0 votes
Contents
  1. Choose the paper and fold signatures
  2. Set up the awl, needle and thread
  3. Sew a saddle stitch notebook
  4. Sew several signatures together
  5. Wrap the sewn spine in a fabric cover
  6. Make a sewn book cover with fabric
  7. Finish the notebook for field use
  8. Sewn Notebook Questions
  9. Do I need special bookbinding tools to make a sewn notebook?
  10. What thread should I use for a hand-bound journal?
  11. How many pages go in each signature?
  12. Can I make a fabric notebook cover without gluing the pages?
  13. What is the difference between saddle stitch and sewn binding?
  14. How do I keep a handmade notebook from falling apart?

A sewn handmade notebook is folded paper sections joined with thread through a pierced spine, then wrapped in a cover. You fold the pages into signatures, punch holes along the fold, sew them together, and glue the sewn spine into a board cover. The same sequence works for a slim field sketchbook or a thicker hand-bound journal.

  • Fold the pages into signatures first, so the sewing holes follow the fold and the pages open flat.
  • A needle and awl make cleaner holes than a sharp pin pushed through cold paper.
  • Linen bookbinding thread holds a sewn spine better than cotton, which stretches with use.
  • Saddle stitch binding suits a slim notebook, while multiple signatures make a thicker hand-bound book.
  • A fabric cover is glued around a board core, not sewn to the pages, so the spine can open freely.

Choose the paper and fold signatures

Signatures are small groups of folded sheets that make up the notebook pages. A signature of a few sheets folded together forms the basic unit of sewn binding. Keep each signature fairly thin, so the fold closes cleanly and the thread pulls tight without tearing the paper.

Fold every sheet along the same line and press the fold with a bone folder or the back of a spoon. Folded paper sections stack more evenly when the folds are sharp and aligned. A field sketchbook benefits from paper heavy enough to take pencil and light watercolor without buckling.

Stack the signatures in order and tap the folded edges against a flat surface to square them. The folded edge of each signature becomes the sewn spine, and the open edges become the fore edge. Trim the open edges only if you want an even block, because cutting removes paper.

Set up the awl, needle and thread

Bookbinding awl and needle are the two tools that decide how clean the sewing looks. An awl pierces the fold, and a needle with an eye wide enough for the thread carries it through. Use a needle that matches the thread size, so the thread does not fray as it passes.

Linen bookbinding thread is waxed to reduce tangling and to hold a knot. A waxed thread glides through the paper and grips in the finished spine. Cut a length of thread that feels comfortable to pull, since a very long thread tangles and twists.

Mark the sewing stations along each fold with a pencil before punching. Stations are the holes the thread passes through, and even spacing keeps the sewn spine straight. Punch through the whole stack of one signature at a time with the awl.

Sew a saddle stitch notebook

Saddle stitch binding is the simplest sewn notebook for a slim book, and it uses one line of thread along the center fold. The pamphlet stitch is the same idea, joining a single folded section with a few stitches tied inside the fold. A thin notebook for a pocket or a field bag suits this method.

Punch an odd number of holes through the center fold, with one hole at the top and one at the bottom. Thread the needle and start from the inside center hole, leaving a tail. Pass the needle out, around the spine, and back in at the next hole, working to one end and then the other.

Finish with both thread ends inside the fold and tie them around the long stitch that runs down the spine. A knot tied around the spine thread stays secure without glue. Press the finished notebook under a weight to flatten the fold.

Sew several signatures together

A hand-bound book with many pages needs the signatures joined along a sewn spine, often called a running stitch or a linked stitch. Each signature is sewn to the one before it, so the whole block holds as one piece. This is the hand-bound journal method for a book that opens flat across many pages.

Punch matching stations through every signature using a template or a marked guide. Sew the first signature alone, then link each following signature to the previous one at the stations. Keep the thread tension even, because a loose stitch lets the signatures shift and a tight stitch puckers the fold.

Tie off the thread at the last signature and press the sewn block flat. A sewn spine that is even and tight will sit straight in the cover. If the block feels loose, sew it again with firmer tension rather than adding glue to the folds.

Wrap the sewn spine in a fabric cover

A fabric notebook cover is built around a stiff cover board, and the sewn block is attached to it rather than wrapped directly. Cut two boards for the front and back and a narrow spine strip, then cover them with fabric. The fabric is folded over the board edges and glued on the inside.

Measure the sewn block before cutting the boards, and add a small allowance at the fore edge and the top and bottom. The cover board should extend slightly past the pages to protect them. A fabric notebook cover made this way keeps the sewn spine free to open.

Glue the first and last pages of the sewn block to the inside of the boards, leaving the spine uncovered. Endpapers hide the board and give the notebook a finished inside. Press the closed notebook under a weight while the glue dries.

Make a sewn book cover with fabric

A sewn book cover can also mean fabric stitched around the boards instead of glued. Stitching the fabric to a backing gives a soft cover that bends, while glue gives a firm one. Either way, the cover holds the sewn spine and protects the pages.

Cut the fabric with a margin on every side, then fold and press the margin before attaching it. Pressing the fold makes the edge lie flat against the board. Hand stitching around the edge with a simple running stitch joins fabric to board without a machine.

Attach the sewn block to the finished cover last, so the cover is complete before the pages go in. A cover made ahead of the block can be fitted and adjusted without disturbing the sewing. Keep glue away from the thread line, because glue stiffens the spine and stops the book opening flat.

Finish the notebook for field use

A field sketchbook binding should open flat and take wear in a bag. Press the finished notebook closed under a weight, then open and flex each signature gently. Flexing the sewn spine loosens the thread slightly and helps the pages lie flat.

A handmade notebook for outdoor use benefits from a firm cover board and a fabric that wipes clean. Keep pencil and a small sharpener in the field bag rather than clipped to the pages. A sewn notebook with a fabric cover sits well in a pocket or a field bag without a separate case.

Label the cover or the first page so the notebook is easy to find among other gear. Store the notebook flat and away from damp, since paper and thread both take up moisture. A dry, flat store keeps the sewn spine straight between outings.

Sewn Notebook Questions

Do I need special bookbinding tools to make a sewn notebook?

No, a sewn notebook can be made with an awl, a needle and thread, plus a bone folder or spoon for pressing folds. An awl and a bookbinding needle make the work cleaner than a pin and a sewing needle. A cutting mat and a ruler help keep the signatures even.

What thread should I use for a hand-bound journal?

Linen bookbinding thread is the choice for a hand-bound journal because it holds tension and resists stretching. Wax the thread before sewing to reduce tangling and to help the knot grip. Cotton thread works for a light notebook but stretches more over time.

How many pages go in each signature?

Each signature holds a small group of folded sheets, and the count depends on the paper weight and the thickness you want. Thin paper folds better in slightly larger groups, while heavy paper needs fewer sheets per signature. Test one folded group before preparing the rest.

Can I make a fabric notebook cover without gluing the pages?

Yes, a fabric notebook cover can hold the sewn block with endpapers alone, leaving the spine free. The sewn block is attached at the first and last pages, and the cover wraps the boards. Avoid gluing the spine, because glue stiffens it and stops the book opening flat.

What is the difference between saddle stitch and sewn binding?

Saddle stitch binding joins one folded section with a single line of thread along the center fold. Sewn binding joins several signatures with a linked stitch along a sewn spine. Saddle stitch suits a slim notebook, and sewn binding suits a thicker hand-bound book.

How do I keep a handmade notebook from falling apart?

Even thread tension and a firm knot keep a handmade notebook together, and pressing the block flat after sewing helps. Keep the sewn spine free of glue so the thread can move as the book opens. Store the notebook flat and dry, since damp paper weakens the fold.

Read next

Latest articles