Wooden Bird Feeding Station
A plain guide to making a wooden bird feeding station: picking untreated timber, joining the frame, adding drainage holes, and finishing the wood for weather.
Contents
- Choose untreated timber for the frame
- Join the post and arms with screws
- Add drainage and an outdoor finish
- Questions About Wooden Feeding Stations
- How do I make a wooden bird feeding station?
- What kind of wood should I use for a bird feeding station?
- Do I need drainage holes in the seed tray?
- How should I finish the wood on the station?
A wooden bird feeding station is a post-and-arm frame that holds feeders above the ground and out of reach of wet soil. You can make one from untreated timber, cut to a plan you set out before any sawing, and joined with screws. The page explains how to make a wooden bird feeding station step by step, then answers the questions that come up along the way.
Choose untreated timber for the frame
Untreated timber is the right wood for a bird feeding station because it carries no chemical preservative. Treated lumber and old painted boards can leach substances that birds should not peck at. Pick a straight, dry board free of large knots, and match your post size to the weight of the feeders it will hold. Wood selection for bird feeders depends on how wet your ground stays, so ask a timber yard about rot resistance before you buy.
Join the post and arms with screws
Screws and joints carry the load on a wooden bird feeding station, so plan them before you cut anything. Fix the cross arms to the post with long exterior-grade screws driven through pilot holes to stop the wood splitting. A diagonal brace under each arm takes the bounce out of a heavy feeder and keeps the joint tight. Check every joint by hand before you raise the post, and tighten any screw that moves.
Add drainage and an outdoor finish
Drainage holes let rain run out of the seed tray instead of soaking the food. Drill small holes in the lowest point of each tray and tilt it a little so water finds them. An outdoor wood finish such as a clear oil or a bird-safe stain slows the weathering of the post and arms. Keep finish off the feeding surfaces, and let every coated part dry fully before you hang a feeder.
Questions About Wooden Feeding Stations
How do I make a wooden bird feeding station?
You make a wooden bird feeding station by setting a post in the ground and fixing arms to it to hold feeders. Cut untreated timber to your own plan, drill pilot holes, and join the parts with exterior screws. Add drainage holes to the trays, then apply a bird-safe outdoor finish and let it dry. A post that carries several feeders needs a deeper footing than a single small one.
What kind of wood should I use for a bird feeding station?
Untreated timber suits a bird feeding station because it holds no preservative that birds might ingest. Wood that resists rot without treatment, such as cedar or oak, lasts longer in wet ground. Avoid painted boards, treated lumber and plywood that can separate in frost. Ask your timber supplier which untreated boards suit outdoor use in your climate.
Do I need drainage holes in the seed tray?
Yes, drainage holes keep a seed tray from holding rainwater and spoiling the food. Drill small holes at the lowest point of the tray and set the tray at a slight tilt so water runs to them. Wet seed clumps and molds, and birds then leave it alone. Clear the holes with a thin wire when debris blocks them.
How should I finish the wood on the station?
An outdoor wood finish slows weathering and keeps the joints sound on a wooden bird feeding station. A clear oil soaks into the timber, while a bird-safe stain adds color and some protection from sun. Keep finish away from the feeding surfaces where birds perch and peck. Recoat the post and arms when water stops beading on the surface.