PRAIRIE FIELD NOTES / MONTANA

Wire Mesh Fence Repair for Prairie Plantings

How to repair a wire mesh exclosure around prairie plantings: fix broken ties, patch mesh tears, reset posts and stretch a sagging fence line.

3 min read1 viewsWire Mesh Fence Repair for Prairie Plantings
— · 0 votes
Contents
  1. Find damage before repairing
  2. Patch mesh tears and gaps
  3. Reset posts and stretch wire
  4. Questions about prairie exclosure repair
  5. How do I start a wire mesh fence repair?
  6. What does exclosure fence repair involve?
  7. How do I fix a sagging fence line?
  8. Can I replace fence posts in a prairie planting myself?

Wire mesh fence repair for prairie plantings means restoring the exclosure fence that shelters young prairie plants from browsing animals. A prairie planting fence fails at a few predictable places: broken wire ties, mesh tears and gaps at the soil line, posts pushed out of plumb, and a sagging fence line between posts. Repairing those points keeps the exclosure doing its job without rebuilding the whole run. This page explains how to find the damage, patch mesh sections, and bring the stretch back into the wire.

Find damage before repairing

Walk the whole fence line and read the wire before you carry tools out. Check every wire tie, each post, the bottom edge where animals push, and the corners where tension collects. A sagging fence line often starts at one loose tie or one leaning post, not along the full span. Mark each fault so the repair order follows the damage rather than the length of the fence.

Patch mesh tears and gaps

Mesh tears along the bottom edge let animals push through, so patching fence gaps matters more than the size of the hole. Cut a patch of the same mesh larger than the tear and lace it to the sound wire on all sides with wire ties. Bend cut wire ends inward so they cannot catch a person or an animal. For gaps at the soil line, fasten the mesh down and cover the lower edge with soil or a firm apron.

Reset posts and stretch wire

Replacing fence posts starts with removing the leaning post and setting a new one below the frost depth for your ground. A post that moves under hand pressure will not hold tension, so firm the soil around it before you pull wire. Stretching wire mesh means working from a solid end and pulling evenly along the line with a fence stretcher. Fasten the wire to each post as you go so the tension stays spread across the run.

Questions about prairie exclosure repair

How do I start a wire mesh fence repair?

A wire mesh fence repair starts with a full walk of the fence line and a list of faults. Mark broken wire ties, mesh tears, loose posts and any sagging fence line before you bring out tools. Fixing loose ties and leaning posts first restores the tension the patches will need. Then work through the mesh damage from one end of the run to the other.

What does exclosure fence repair involve?

Exclosure fence repair restores the barrier that keeps browsing animals away from young prairie plants. The work covers re-tying wire, patching mesh sections, resetting posts and pulling a slack line taut again. Exclosure fencing protects plants rather than livestock, so the bottom edge and small gaps deserve close attention. A fence with a low gap is not doing its job even when the rest looks sound.

How do I fix a sagging fence line?

A sagging fence line is fixed by finding the post or tie that lost hold rather than by pulling the whole span. Set any leaning post firmly first, since stretching wire against a loose post only pulls it over again. Then pull the mesh with a fence stretcher and refasten it at each post along the run. Replace ties that have cracked or rusted through while the wire is slack.

Can I replace fence posts in a prairie planting myself?

Replacing fence posts is work a landowner can do with hand tools on a short run of exclosure fence. Digging out a broken post and setting a new one below frost depth takes steady effort but no specialist skill. Tensioning wire mesh across a long fence line needs the right stretcher and a helper. Where a post is set in difficult ground or the run is long, a trained fencing specialist should do the job.

Latest articles