Lifting Equipment Pre-Use Checklist
How to run lifting equipment pre-use checks: inspect slings, straps, hooks and shackles, read the load rating, spot damage and keep lifting gear records.
Contents
- Read the load rating first
- Inspect slings, straps, hooks and shackles
- Record the checks and remove faults
- Questions about lifting equipment pre-use checks
- What is a lifting equipment pre-use checklist?
- What do pre-use checks on lifting equipment include?
- Should damaged lifting gear be used if the damage looks small?
- Who is allowed to inspect lifting gear before a lift?
A lifting equipment pre-use checklist is the short inspection you complete before each lift, so faults are found while the load is still on the ground. The check covers slings and straps, hooks and shackles, the load rating and safe working load, and visible damage. It takes minutes, and it protects both the people under the load and the gear itself.
Read the load rating first
Every item of lifting gear carries a load rating and a safe working load, and the pre-use check starts by confirming both are legible. A tag that is missing, painted over or unreadable leaves you unable to prove what the gear can hold. Match the rating of each sling, hook and shackle to the weight and shape of the load. Gear with no readable rating stays out of service until a competent person identifies it.
Inspect slings, straps, hooks and shackles
Slings and straps fail at points you can see, so run each one through your hands and look along its full length. Cut fibers, frayed edges, heat glazing, chemical staining and broken stitching are grounds to reject a strap. Hooks and shackles need a check for cracks, bent bodies, worn threads and a working safety latch. Distortion or deep wear on a hook or pin means the item leaves service.
Record the checks and remove faults
Lifting gear records show that inspection before each lift happened and what was found. Note the item, the date and any fault, then tag faulty gear and move it away from the lifting area. A trained specialist carries out repairs and any test needed after damage, not the person doing the pre-use check. Storage matters too, since damp, sunlight and grit shorten the life of slings and straps.
Questions about lifting equipment pre-use checks
What is a lifting equipment pre-use checklist?
A lifting equipment pre-use checklist is a set sequence of checks made on gear immediately before a lift. It covers the load rating and safe working load, the condition of slings and straps, the state of hooks and shackles, and any visible damage. The aim is to catch a fault before the load leaves the ground.
What do pre-use checks on lifting equipment include?
Pre-use checks on lifting equipment include reading the load rating and safe working load on each item. The check then looks for damage such as cuts, fraying, cracks, bends and worn threads across slings, straps, hooks and shackles. Safety latches and pins must work, and any fault found is recorded and the item removed from service.
Should damaged lifting gear be used if the damage looks small?
No, damaged lifting gear should be withdrawn from service even when the damage looks minor. A cut fiber, a bent hook or a worn shackle pin reduces strength in a way you cannot judge by eye. Tag the item, keep it apart from the lifting area and pass it to a trained specialist for assessment.
Who is allowed to inspect lifting gear before a lift?
A trained and competent person inspects lifting gear before a lift, and the operator of the gear often carries out the pre-use check. Repairs, tests and any decision to return damaged gear to service belong to a qualified specialist. Formal lifting equipment inspection at set intervals is a separate task from the pre-use check.