How to Build a DIY Barn Door Star Tracker
A plain guide to a barn door star tracker for astrophotography: the hinged platform, the threaded drive rod, polar alignment and the camera mount.
Contents
A barn door star tracker is a homemade hinged tracking platform that turns a camera slowly to follow the stars during a long exposure. You build it from two boards, a hinge and a threaded drive rod, then align it with the celestial pole before a shot. The pages below explain the build, the drive and the alignment so you can capture star fields with a simple DIY star tracker for astrophotography.
Boards, hinge and drive rod
The tracker rests on two flat boards joined along one edge by a hinge, and the upper board carries the camera. A threaded drive rod pushes the upper board open at a slow, steady rate, so the hinge line becomes the pivot. Build instructions start with a straight hinge line, a rigid lower board and a smooth rod that turns without binding. Keep the whole assembly stiff, because any flex in the boards blurs a long exposure.
Turning the rod at the right rate
The drive rod must open the hinge at an angular rate that matches the turning of the sky, and the rate depends on the rod thread pitch and the distance from the hinge. A finer thread and a longer hinge-to-rod spacing both slow the movement for a given turn of the rod. A small motor or a hand crank turns the rod, and a simple mark on the rod lets you check the pace. Any error in the rate shows as star trails rather than points.
Aligning the hinge with the pole
Polar alignment sets the hinge line of the platform parallel to the Earth's axis, so the camera swings with the stars. Point the hinge toward the celestial pole for your latitude and use the pole star as a rough guide. A sighting tube or a straight edge along the hinge helps you set the angle. Poor alignment turns round stars into curved trails across the frame.
Barn Door Tracker Questions
What is a barn door star tracker?
A barn door star tracker is a homemade hinged tracking platform that moves a camera to follow the stars. Two boards joined by a hinge open slowly under a threaded drive rod, and the camera rides on the top board. The motion cancels the apparent turning of the night sky during a long exposure. It is a simple DIY star tracker for wide star fields and steady camera work.
Do I need a motor for a barn door tracker?
A motor is not required, because a hand-turned crank on the threaded rod can drive the platform. A slow motor gives a steadier rate and frees your hands, but it adds parts and needs its own power. Hand turning suits short sessions where you can watch the rod mark closely. Either way, the drive rod must turn smoothly so the camera does not jump.
What camera mount fits a barn door tracker?
A ball head or a small pan head bolted to the upper board makes a workable camera mount. The head lets you aim the camera while the platform stays aligned with the pole. Fix the head firmly, because a loose mount shifts under the weight of a lens. Balance the camera over the board so the drive rod carries a light, even load.
How do I set polar alignment on a homemade tracker?
Polar alignment means setting the hinge line parallel to the Earth's axis, aimed at the celestial pole. Set the hinge angle to your latitude and turn the whole platform until the hinge points at the pole star. A sighting tube fixed along the hinge makes this easier to repeat. Check the alignment again after you mount the camera, since the added weight can shift the platform.