How Much Water a Prescribed Burn Needs
Learn how prescribed burn water volume is planned, from gallons per acre to tank capacity, holding water on burn day, mop-up and the suppression reserve.
Contents
- Estimating gallons per acre
- Matching water tank capacity to the unit
- Holding water on burn day
- Prescribed burn water questions
- What is a fire suppression water reserve?
- How much mop-up water should a crew plan for?
- Does weather change the water volume a burn needs?
- Where does the refill water come from on burn day?
How much water a prescribed burn needs depends on the fuels, the size of the unit, the weather and the crew plan, so the figure comes from a written burn plan rather than a single number. Planners estimate water for three jobs: wetting firebreaks and edges, holding water ready on burn day and soaking smoldering material during mop-up. The plan sets a fire suppression water reserve that stays untouched unless a spot fire or escape demands it.
Estimating gallons per acre
Gallons per acre is the planning figure that turns a unit size into a starting water budget for prescribed fire. The figure rises with heavy fuel loads, dry conditions, rough terrain and the length of firebreak that must be wetted before ignition. A burn plan states its own rate for the unit, so treat any single number as a local planning value and not a rule. Crews record actual use after each burn to sharpen the estimate for next time.
Matching water tank capacity to the unit
Water tank capacity on the burn unit has to cover the planned job plus the reserve, and refill access decides how large that tank must be. A unit far from a hydrant or fill point needs more carrying capacity or a tender that shuttles water during the burn. Small slip-on tanks suit light grass units with a short firebreak, while timber fuel and long edges call for larger tanks. The plan should name the refill source and the travel time to it before ignition.
Holding water on burn day
Holding water on burn day means keeping a charged line, a full tank and a pump ready at the ignition point before the first drip torch is lit. Crew members check pump function, hose condition and nozzle patterns during the briefing so a failure is found before fire is on the ground. Water goes first to the downwind edge and the firebreak beside it, where an escape would spread fastest. Mop-up water then soaks smoldering logs, stumps and duff until they are cold to the touch.
Prescribed burn water questions
What is a fire suppression water reserve?
A fire suppression water reserve is the portion of the tank held back for a spot fire or an escape, and it is never used for routine mop-up. The burn plan sets the reserve size and names who may release it. Using the reserve on ordinary work leaves the crew without a buffer when conditions change. Refill the reserve before the next ignition segment begins.
How much mop-up water should a crew plan for?
Mop-up water depends on how much woody fuel, duff and root mass the fire leaves smoldering, so the burn plan estimates it per unit rather than per acre alone. Deep duff and large logs drink far more water than grass stubble. Crews soak until the material is cold and no smoke rises, then check again before leaving. Extra water carried for mop-up keeps a crew from draining the suppression reserve.
Does weather change the water volume a burn needs?
Weather changes the water volume a prescribed burn needs because wind, humidity and fuel moisture shift how fast edges dry and spot fires start. A dry, windy day pushes the plan toward more water on the downwind break and a larger reserve. Damp fuels reduce consumption but can make smoldering mop-up slower. The burn boss compares the day's forecast to the plan's prescription before deciding to ignite.
Where does the refill water come from on burn day?
Refill water comes from a source named in the burn plan, such as a hydrant, a stock tank or a tender truck that shuttles between a fill point and the unit. The plan records the travel time so the crew knows how long a tank must last. A dry source or a locked gate found on burn day stops the operation. Confirm access and volume at the source during the week before the burn.