Growing Degree Days Formula for Corn
How the corn growing degree days formula works, from the 50 F base temperature to daily highs and lows, with planting date and silking timing in view.
Contents
The growing degree days formula for corn adds the daily high and low, halves that sum, and subtracts a base temperature of 50 F. Growers use the result, measured in corn growing degree units, to track heat accumulation from planting date through silking timing and toward a maturity estimate. The method turns ordinary weather records into a running total that follows crop development rather than the calendar.
Doing the daily calculation
The daily growing degree day value for corn comes from the day's maximum and minimum air temperatures. Add the high and the low together, divide by two, then subtract the 50 F base temperature. A day with a high of 80 F and a low of 60 F averages 70 F and yields 20 degree units. Values below zero are set to zero, because cold days do not subtract from accumulated heat.
Setting the upper and lower limits
Corn development slows when temperatures climb far above the comfortable range, so many calculations cap the daily maximum. A ceiling near 86 F keeps an unusually hot afternoon from inflating the count beyond what the plant can use. The same base temperature of 50 F acts as the floor, and any average below it contributes nothing. Check which limits a particular calculation uses before comparing totals from different sources.
Reading the running total
Accumulated corn growing degree units begin at the planting date and rise with each warm day. The total helps you compare a field's progress against the heat a hybrid needs for silking timing and for a maturity estimate. A late planting date shifts the whole curve later, even when daily temperatures match an early field. Track the accumulation alongside soil moisture and day length, since heat alone does not describe everything a corn plant experiences.
Corn degree day questions
What is the growing degree days formula for corn?
The growing degree days formula for corn averages each day's high and low temperature and subtracts 50 F. The result is expressed in corn growing degree units and added to a running total. Days that average below the base temperature add zero rather than a negative value. Some versions cap the daily high before averaging so extreme heat does not overstate the count.
Why is 50 F the base temperature for corn?
The base temperature of 50 F marks the threshold below which corn growth essentially stops. Little development occurs when the average daily temperature sits at or under that level. Subtracting the base from each day's average therefore counts only the heat the plant can use. The same figure anchors both the daily calculation and the seasonal total.
How does planting date change the degree day total?
Planting date sets the starting point for accumulating corn growing degree units. A later planting date begins the count later, so the crop reaches a given total further into the season. Two fields can share identical daily temperatures yet differ in accumulated heat because their counts started on different days. Record the planting date whenever you compare totals between fields or years.
Can degree days predict silking timing?
Degree day totals give a useful signal for silking timing because silking follows a fairly steady heat requirement for a given hybrid. The accumulated total from planting date is compared with the figure the hybrid needs to reach that stage. Weather that departs from normal shifts the actual date around the estimate. Use the total as a guide and confirm progress by inspecting the field.