Berlese Funnel Not Working: Troubleshooting
Work through a Berlese funnel that is not working: check the heat lamp, mesh screen, drying leaf litter and collection jar, and keep specimens from escaping.
Contents
- Check the heat lamp height
- Mind the mesh screen and litter depth
- Watch the collection jar for escape
- Berlese Funnel Troubleshooting Questions
- Why is my Berlese funnel not working at all?
- How warm should the leaf litter get in a Berlese funnel?
- How do I stop specimens from escaping the collection jar?
- Does the mesh screen affect extraction efficiency?
A Berlese funnel not working is nearly always a problem with one of four parts: the heat source above the sample, the mesh screen, the drying leaf litter, or the collection jar below. The funnel drives small invertebrates downward out of leaf litter as the litter dries from the top. Each part of that chain has to do its job for extraction to happen. This page shows how to test each part and what to adjust.
Check the heat lamp height
A heat lamp placed too high dries the leaf litter so slowly that invertebrates have little reason to move downward. A lamp placed too close can overheat the top layer and kill specimens before they travel. Hold your hand at litter level to judge the warmth, then adjust the lamp until the surface feels gently warm rather than hot. The right distance depends on the lamp wattage and the depth of the litter, so set it by feel rather than by a fixed gap.
Mind the mesh screen and litter depth
The mesh screen must hold the leaf litter while letting invertebrates pass through without gaps at the rim. Litter packed too deep slows drying at the base and leaves animals stranded above the funnel. Spread drying leaf litter in a loose, even layer so warm air reaches the whole sample. A screen that sags or tears under the weight lets litter drop into the funnel and blocks the path down.
Watch the collection jar for escape
Specimen escape often happens at the collection jar, where invertebrates climb back out of the preservative or walk around the funnel rim. A jar that sits loosely against the funnel leaves a gap that animals follow upward and out. Seat the jar snugly and keep the preservative level deep enough to catch what falls. Check the rim of the funnel for animals that have walked over the edge instead of dropping.
Berlese Funnel Troubleshooting Questions
Why is my Berlese funnel not working at all?
A Berlese funnel that produces nothing usually has no working heat source or a sample that is already dry. Confirm the lamp is on and warms the litter surface, and use fresh leaf litter that still holds moisture. If both are fine, look for a blocked screen holding animals above the funnel.
How warm should the leaf litter get in a Berlese funnel?
The leaf litter should feel gently warm, not hot, at the surface under the lamp. Heat that dries the top layer too fast kills invertebrates before they move down. The exact warmth depends on the lamp, the litter depth and the room, so adjust by touch and by watching the catch.
How do I stop specimens from escaping the collection jar?
Specimens escape a collection jar when it sits loosely against the funnel or holds too little preservative. Press the jar snugly to the funnel outlet so no gap remains. Keep the preservative deep enough that anything falling in is caught at once, and check the funnel rim for animals that walked over it.
Does the mesh screen affect extraction efficiency?
The mesh screen does affect extraction efficiency, because a screen that is too fine or clogged slows drying and traps invertebrates above it. Use a mesh that holds the litter while letting small animals pass. Keep the screen taut and clear of packed litter so warm air and animals can move through.