# Windproof DIY Bird Feeder for Prairie Winds

Build a homemade platform feeder that stays put in open grassland wind, with a weighted base, a low profile and a sheltered placement plan.

A windproof DIY bird feeder for prairie winds keeps seed on the tray instead of on the grass, and it starts with weight, a low profile and a fixed anchor point. Open grassland offers little to break the wind, so a homemade feeder must resist lift and sliding on its own. This page explains how to build and site a wind-resistant feeder for windy areas, from the weighted base to the sheltered spot behind a windbreak. 

## Start with a weighted base 

A weighted base holds a windproof platform feeder down when gusts push against the roof or tray. Set a heavy flat stone or a sand-filled container on the tray frame or bolt the feeder to a buried post. Keep the weight low and centered so the feeder does not tip, and add a rim to stop seed from sliding off. Check that the base sits flat on the ground, because a rocking feeder loosens itself in steady wind. 

## Keep the profile low and open 

A low, open platform feeder lets prairie wind pass over and through instead of lifting it. Build the tray close to the ground on short legs and leave the sides open with a mesh floor that drains rain and lets air move. A solid roof catches gusts like a sail, so use a small roof or a slatted top if you want cover. Rough-sawn lumber and deep tray sides add grip and keep seed from spilling over the edge. 

## Site the feeder behind cover 

Sheltered feeder placement matters as much as the build in open grassland. Set the feeder on the downwind side of a shrub row, a fence line or a low bank, where the wind slows before it reaches the tray. Leave a clear approach for birds and a gap from the cover so predators cannot hide close by. In a fully open yard, angle the feeder so its narrow edge faces the prevailing wind and anchor that edge first. 

## Questions about wind-resistant feeders 

### What makes a homemade platform feeder work in wind? 

Weight, a low profile and an anchor make a homemade platform feeder work in wind. A heavy base set on the ground keeps the tray from sliding, and short legs keep it out of the strongest airflow. An open side lets gusts pass through rather than push the feeder over. Bolting the frame to a buried post adds a fixed hold when gusts arrive. 

### How do I place a bird feeder in a windy area? 

Place a bird feeder on the downwind side of a windbreak, such as a shrub row or a fence line, in a windy area. The cover slows the airflow before it reaches the tray and reduces seed loss. Keep a gap between feeder and cover so birds can watch for predators. Where no cover exists, face the narrow edge of the feeder into the prevailing wind. 

### Is a windproof bird feeder different from a wind-resistant one? 

A windproof bird feeder blocks wind from reaching the seed, while a wind-resistant feeder simply holds its place in gusts. Full windproofing needs a solid shelter around the tray, and that can block the birds' view and trap damp. A wind-resistant design with weight, a low profile and open sides suits [prairie wind exposure](/articles/how-wind-shapes-prairie-grasslands/) better for a homemade build. Pair it with a sheltered spot for the most reliable result. 

### Which materials suit a DIY feeder for open grassland? 

Sturdy, heavy materials suit a DIY feeder for open grassland because light parts lift and rattle in gusts. Rough-sawn lumber, galvanized mesh and a stone or sand weight hold up and drain water well. Avoid thin plastic sheeting and tall solid roofs that catch wind like a sail. Check the joints and anchor after strong winds and tighten anything that has worked loose.
