# How to Weave a Grass Skirt

Learn how to weave a grass skirt from gathered prairie grasses, with steps for preparing strands, tying a waistband and building rows for a hula skirt costume.

You weave a grass skirt by gathering and drying long grass strands, tying them in bundles onto a waist cord, and layering rows downward until the skirt covers the length you want. The craft needs only grass, a strong cord and patient hands, and it suits a hula skirt costume as well as wearable grass craft for warm-weather events. The steps below cover strand preparation, waistband tying and row building. 

- Long, flexible grass strands are easier to tie and hang evenly than short, brittle ones.
- A knotted waist cord carries the weight, so anchor the strands to it rather than to each other.
- Strand lengths set the finished skirt length, so measure before you cut.
- Rows build from the top down, with each new row tied onto the cord above it.
- Dried grass shrinks and stiffens, so tie knots snug but check the fit before wearing.
 

## Choose and prepare grass strands 

Grass for weaving needs length, flexibility and a clean cut, so pick stalks that bend without snapping. Prairie grasses with tall, smooth stems work well when gathered before they go fully dry and brittle. Cut each stalk near the base and strip the seed heads and side leaves away. 

Strand lengths decide the finished skirt, so measure the length you want and add a few inches for the knot and the waistband. Cut a bundle of strands to that length and lay them side by side on a flat surface. Equal lengths keep the hem level and the weave tidy. 

Fresh grass holds moisture and can shrink as it dries, so spread the strands in a shaded, airy place for a few days. Turning the bundle partway through helps the whole batch dry evenly. Skip this step and the knots may loosen once the grass shrinks. 

## Gather the tools for tying 

A grass skirt needs very little equipment, but the right tools keep the work steady and the knots firm. A strong cord forms the waistband, and a second cord or a clip holds the strands in place while you tie. Sharp shears, a tape measure and a flat work surface round out the kit. 

Cord choice matters because it carries the weight of the skirt and sits against the waist. A braided natural fiber cord or a sturdy cotton cord holds knots well and resists slipping. Avoid thin twine that can cut into damp grass or stretch under load. 

A simple workstation helps the rows stay even, since grass strands are long and awkward to hold by hand. Tie the waistband cord between two fixed points, such as two chair backs, at a comfortable working height. The tension keeps the cord straight and the rows level as you tie. 

## Tie the waistband cord 

The waistband cord is the backbone of a grass skirt, so fit it before tying any grass. Wrap the cord around the wearer's waist over light clothing and tie a flat knot that sits snug without pinching. Leave two long tails on the knot for tying the skirt closed later. 

A double waistband adds strength for a heavier skirt or a costume worn over clothing. Fold the cord and knot the ends to form a loop, or run two cords parallel and tie them together at intervals. The strands then attach to the doubled band. 

Mark the cord at intervals with a light pencil or a slip of tape to keep strand spacing even. Spacing depends on the look you want: close spacing gives a dense skirt, wider spacing gives a lighter one. Even marks make the finished rows hang straight. 

## Attach the first row of strands 

Attaching the first row sets the pattern for every row after it. Fold each grass strand in half, pass the folded loop behind the waistband cord, and pull the two loose ends through the loop. Pull gently until the strand sits snug against the cord. 

Work along the cord from one end to the other, adding strands one at a time. Keep the loose ends pointing down and the fold sitting on top of the cord. A small comb run through the strands helps them lie flat as the row fills in. 

Tying grass strands in a single loop knot makes them easy to adjust, since a loose strand can be shifted before the next one goes on. Check that neighboring strands overlap slightly so no gaps show when the skirt hangs. Finish the first row before starting a second. 

## Build rows downward 

A grass skirt grows in rows that hang below the waistband, and each row overlaps the one above. Take a fresh strand, fold it over the first row of grass just below the cord, and tie it off in the same loop knot. Work across the skirt in a straight line. 

Rows should sit close enough that the knots of the new row hide behind the strands of the row above. Staggering the knots slightly, rather than lining them up, keeps the surface smooth. Continue adding rows until the skirt reaches the length you measured. 

The lower rows carry more swing, so tie them a touch looser than the top rows. A gentle tug on the finished rows shows whether any strand pulls free. Retie loose strands before moving on, since fixing them later is harder. 

## Hula skirt style and costume touches 

A hula skirt look comes from volume and movement, so use more strands per row and a slightly longer hem than a plain grass skirt. Layering two rows close together near the waist gives the skirt a fuller top edge. Longer strands at the back add sway when the wearer moves. 

A grass skirt costume often mixes materials, and dried grass pairs well with raffia or paper twist for contrast. Keep the added material in the same weight class so the rows hang evenly. Tie any decorative cord or band above the first grass row. 

Costume wear means the skirt may be put on and taken off many times, so test the waist tie repeatedly. A cord that slips loose needs a second knot or a small toggle. Check that no sharp grass ends poke into the wearer's skin. 

## Finish, fit and care for the skirt 

Finishing a grass skirt means trimming the hem, securing the waist tie and checking the fit on the person who will wear it. Trim the ends level with sharp shears, cutting a little at a time. A level hem makes the skirt hang straight and look deliberate. 

Grass dries and stiffens over time, so store the skirt flat or hung from the waistband rather than folded in a bag. Damp storage invites mold, which stains grass and weakens the cord. A dry, shaded spot keeps the strands supple for the next wearing. 

Check the knots before each wearing and retie any that have worked loose. A skirt that sheds strands can be patched by tying a new strand over the gap. Where a skirt is meant to last, a fiber specialist can advise on treating the grass. 

## Questions About Weaving Grass Skirts 

### How do I weave a grass skirt if I have never woven before? 

Weaving a grass skirt needs no loom or prior weaving skill, because the work is tying strands onto a cord in rows. Practice the loop knot on a short cord with a few spare strands first. Once the knot feels steady, tie the waistband and build the rows from the top down. 

### What grass works for a grass skirt? 

Tall, flexible grass with smooth stems works well for a grass skirt, and prairie grasses gathered before they turn brittle are a good source. The grass should bend without cracking and hold its shape after drying. Avoid short or woody stems that snap when folded. 

### How long should the grass strands be for a hula skirt? 

Strand length follows the finished skirt length, so measure from the waist to where the hem should fall and add a few inches for the knot. A hula skirt style often calls for a longer hem than a plain skirt. Cut every strand to the same length for an even row. 

### Can I make a grass skirt without tying knots? 

A grass skirt can be built by weaving strands through a cord instead of tying each one, but the tied loop method holds strands more securely. Weaving through a cord suits a light costume that will not be worn hard. Tied strands stay in place better on a skirt meant for repeated wear. 

### How do I keep a grass skirt from falling apart? 

A grass skirt stays together when each strand is tied snugly to the cord and the waistband is strong enough to carry the weight. Check the knots before wearing and retie any loose strand. Storing the skirt dry and flat protects both the grass and the cord.
